Are Steam Showers Expensive to Run? Here’s What Actually Drives the Cost

By admin | Uncategorized

Nov 03

Are Steam Showers Expensive to Run? Here’s What Actually Drives the Cost

A Vidalux Fusion 1200 steam shower cabin in Black, shown alone on a seamless pale warm-grey studio backdrop with a soft floor shadow, no room or props.

Not inherently. A steam shower’s generator (typically 3kW to 9kW for a home installation) only draws full power while heating up, then briefly to hold temperature. At October 2026’s Ofgem price cap rate of 26.32p per kWh, that’s roughly 79p to £2.37 an hour at full draw… real sessions cost less.

You’re probably choosing between models right now, or you’ve just had one fitted and the “what’s this going to do to my electricity bill” question has started nagging at you. Fair enough… it’s a big-ticket purchase.

By the end of this, you’ll know what draws the power, what that costs at today’s electricity rate, and the three things that move your own number up or down. We’ll show you the working, not a made-up headline figure.


What Actually Draws the Power (and When)

Here’s the bit people miss: a steam generator doesn’t run at full power for your entire session. It draws its full rated output while heating the water to steam, then a temperature probe takes over, holding your chosen setting rather than “running the unit harder than necessary.”

Does a steam shower use a lot of electricity? During heat-up, yes, it pulls its full rated power. Once it’s at temperature, no… the thermostat cycles the element on and off to hold it there, rather than running flat-out for the whole session.

A generator’s kW rating is a ceiling, not a constant draw. Treat it as the latter and you’ll scare yourself with a number that’s higher than reality.

Worth knowing: this is also why a steam generator needs its own dedicated electrical circuit. A 6kW generator needs 6,000 watts on demand, far more than a standard shower circuit supplies, even though it isn’t drawing that continuously. Every size, from 3kW up to the 12kW-15kW units used in larger rooms, needs this dedicated supply, fitted under Part P electrical safety rules (Planning Portal, Approved Document P).


The Real Numbers: Generator Size and Today’s Electricity Rate

Domestic steam generators typically range from 3kW (small enclosures) up to 9kW (larger rooms), with 12kW-15kW reserved for large or light-commercial spaces rather than a typical home bathroom.

According to Ofgem’s current energy price cap, the typical Direct Debit electricity customer in Great Britain pays 26.32p per kWh for 1 October to 31 December 2026. Multiply that against a generator’s rated output and you get a cautious ceiling for what an hour at full draw would cost:

  • 3kW generator: roughly 79p an hour at full, continuous draw
  • 4.5kW generator: roughly £1.18 an hour at full, continuous draw
  • 6kW generator: roughly £1.58 an hour at full, continuous draw
  • 9kW generator: roughly £2.37 an hour at full, continuous draw

Straight answer: those are ceilings, not bills. Your actual cost per session sits below these figures, by an amount that depends on your session length and how much of it is heat-up versus hold. We don’t have a sourced, typical session length or duty-cycle percentage to multiply through to a single “£X per shower” figure, so we’re not inventing one just to give you a tidier-looking number. Trust the ceiling, and trust that your real cost sits under it.


What Actually Moves That Number: Size, Length, Frequency

Three things genuinely change your running cost, and none of them are a mystery.

Generator size, matched to the room. A generator is sized to the room it’s heating, and oversizing it for a small enclosure just means paying to heat capacity you don’t need… exact performance depends on insulation, room materials, ventilation and ceiling height, so bigger isn’t automatically better. Buy for the room you’ve got, not the one in the brochure photo. Our steam shower cabins guide covers sizing in more depth.

How long each session runs. Steam showers from both Vidalux, Insignia and Lisna Waters feature fully adjustable, built-in timers that automatically switch off the steam generator after a pre-set duration. A 20-minute session and a 40-minute session aren’t the same bill, and a timer puts that choice in your hands rather than leaving the generator running unattended.

How often you use it. Daily use and twice-a-week use aren’t close to the same annual total… frequency is the single biggest multiplier on your per-session figure We’re not putting a number on “typical use,” since there isn’t one true of most households; it’s worth being honest about your own habits before you budget.

Is a steam shower worth the money? That’s a judgement only you can make once you know the real range, not something we can tell you from here. What we can tell you is that the range is bounded and controllable, not the open-ended risk it can feel like beforehand.


Weighed Against a Standard Shower

A standard electric shower also draws serious power… Vidalux’s Pure E range, for example, pairs an integrated electric shower rated at 8.5kW or 9.5kW, in the same ballpark as a mid-size steam generator.

One thing to measure first: The real cost difference isn’t steam-versus-electric as technologies. It’s session length. A quick electric shower wash is typically shorter than a steam session, and that time difference, not the generator itself, is doing most of the work in any cost gap you’d notice.

Can you take a normal shower in a steam shower cabin? Yes… the design intent is to give you both in one footprint, rather than needing a separate steam room as well as a shower. You can take a normal shower, or run a full steam session, in the same enclosure.

If you’re weighing up specific ranges, the Insignia steam shower cabins guide is a useful next read.

Already know your footprint? Browse the Vidalux steam shower range directly.


Bottom Line

A steam shower isn’t expensive to run by default, and it isn’t free either. The honest answer sits in a bounded range you can work out for your own generator size and habits… not in a single number anyone can hand you upfront.

If you want to see what’s actually available at the size and price point you’re working to, our full steam shower range is the place to start.


Flat-vector diagram showing the formula generator size (kW) times 26.32p per kWh equals cost per hour at full draw, with four ascending steps for 3kW (79p/hr), 4.5kW (£1.18/hr), 6kW (£1.58/hr) and 9kW (£2.37/hr), captioned

Frequently Asked Questions

Q: Does a steam shower use a lot of electricity?
A: During heat-up, a steam generator draws its full rated power (typically 3kW-9kW for a home installation), but once at temperature, a thermostat cycles the element on and off rather than running flat-out for the whole session.

Q: Is a steam shower worth the money?
A: That depends on how you value a steam session against the running cost, which scales with generator size, session length and how often you use it. There’s no single “worth it” answer that fits every household.

Q: How much does it cost to run a steam shower per hour?
A: At full, continuous draw and October 2026’s Ofgem price cap rate (26.32p per kWh), a 3kW generator costs roughly 79p an hour and a 9kW generator roughly £2.37. Real sessions cost less, since the generator cycles rather than running flat-out throughout.

Q: Can you take a normal shower in a steam shower cabin?
A: Yes. A steam shower cabin is designed to give you a full steam room and an everyday shower in the same footprint, so you can take a normal shower or run a steam session without needing a separate room.

Q: Do I need an electrician to install a steam shower?
A: Yes. Every steam generator, regardless of size, needs its own dedicated electrical circuit rather than running off a standard shower circuit, and the installation falls under Part P electrical safety rules for domestic dwellings.


About the Author